Home · Forum · CAN Modules · Partlists · Katalog · press archive · Downloads · Photogallery · WebLinksTuesday, 17. November 2026
System and module list
Modell- und
Kirmesbeleuchtung
kleine Helferlein
ECOS &
CentralStation1
CentralStation2/3 MobileStation2 PC-Schnitte CC-Schnitte
Z-CAN
Z21 / MX10
Gleisbildstellpult Accessories all Modules

Here you can find the descriptions of the little helpers from the books.


Accessories


GBS-PowerBox
CAN-digital-Bahn


The PowerBox-GBS



Content:

General

Connection




General:

The PowerBox-GBS is only needed for building a track control panel when no RoutenMann-GBS is in use and it is ment to provide the modules with a power supply. The modules can be attached on the right- and/or on the left-hand side of the PowerBox.


Because of the direct plugging together there is a considerable less need of space for the modules in the track control panel, as if they would be connected through networkcables instead.

The PowerBox isolates the connected modules completely from the remaining operating voltage and the networkcable is only for handling the data exchange.

That means that a connection to the operating voltage via networkcable does not exist! Only the earths of the two power supplies are connected, so that a common reference point for detectors is obtained.


The supply of the PowerBox-GBS is now effected through a 12 Volts DC power supply unit. (Comparable with StartPunkt2.)

A different voltage from 12Volts DC can damage the GBS-modules.

With this voltage also the older "SwitchManns" can be provided and it is no problem to mix up older modules with newer ones.

The LED on the right-hand side illuminates when a power supply is connected. It extinguishes after the PTC-fuse (that is located onto the PowerBox-GBS) has broken the circuit.
The fuse resets itself automatically after power off and needs not to be replaced. Thus after elemination of an operational fault one can turn the voltage simply on again.


Attention:

A PowerBox-GBS should be stressed maximum with 1,25A current, according to this value the fuse on the module is construed.


up


Connection:

Below you find a picture about the connections of the PowerBox-GBS:




up

Subject to technical changes and errors.

© 2018 by CAN-digital-Bahn

Copyright 2010 - 2025 by Sven Schapmann